JavaScript seems to be disabled in your browser.

You must have JavaScript enabled in your browser to utilize the functionality of this website. Click here for instructions on enabling javascript in your browser.

Above Ground Steps /With Weights/HDPE. Max. Load 300lbs/21.4St has been added to your Cart
Heat Controllers

 

 

 

 

 

 

 

 

 

 

 

Smart Intelligent Pool Control System.

 

 

 

 

The Pool-Smart from Elecro is the intelligent pool control system that allows you to control and maintain your pool to the perfect temperature as economically as possible.
 

The Complete Control Solution For:

  • Electric Heaters
  • Heat Exchangers
  • Heat Pumps
  • Boilers

     

Features:

  • Priority Heating
  • Accurate Temperature Control to 0.5ºC
  • Diagnostic Display

The Pool-Smart is supplied fully equipped with flow switch, temperature sensor probe fitted in custom pipe work T-Piece, for simple integration into any pool technical facility.

For efficient control and operation of your pool equipment.

Q - What is priority Heating?

A - Priority heating is when the Pool Smart digital controller detects that swimming pools temperature has dropped below the required temperature so switches the pool's circulation pump on (via the pump control cable to the pumps contactor) so that the heating product can switch on and heat the pool back to the required temperature. Once the required temperature has been reached the Pool-Smart will switch off the heating product and then also switch off the pools circulation pump.

Q - How do I connect the Pool-Smart to my heating appliance?

A - The installation electrician will need to connect the volt free 'heat out' to the control circuit of the heating appliance, please see below diagram:


Elecro Pool-Smart Wiring Diagram

 

Q - Why does the Pool Smart heater have 2 temperature set points?


A -
The Pool Smart digital controller has been designed to be the most economical heating controller available, by allowing the use of 2 set points you are able to select a higher set point for when fuel is cheaper (i.e. off peak) and then a lower set point for when fuel is more expensive (i.e. peak rate). It is recommended that the lower set point is programmed to be your absolute minimum swimming temperature, if the pool then drops below this temperature during the day the heater can switch on the circulation pump (as described above) and top up the heat to keep the pool at the minimum swimming temperature.